Product ID:PLIOBOND 30
MSDS Date:09/29/1977
FSC:8040
NIIN:00-543-7170
Status Code:A
MSDS Number: CLNJM

GOODYEAR TIRE AND RUBBER CO

1144 E MARKET ST
AKRON, OH 44316-0001
US

Emergency Phone: 216-794-2121

Info Phone: 330-796-1906/613-996-66669(CANADA)

Preparer: ERNEST CARTER

Cage: 73842

GOODYEAR TIRE AND RUBBER CO

AKRON, OH 44316-0001 US

Telephone: 330-796-1906/613-996-66669(CANADA)

Cage: 73842

METHYL ETHYL KETONE

CAS: 78-93-3

RTECS: EL6475000

OSHA PEL 590 MG/M3;200 PPM

ACGIH TLV: 590 MG/M3;200 PPM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

Effects of Overexposure:IRRITATION OF EYES, NOSE, AND THROAT, HEADACHE,
NAUSEA, AND NARCOSIS POSSIBLE AT VERY
HIGH VAPOR CONCENTRATIONS.

First Aid:IF INHALED, REMOVE TO FRESH AIR. IN CASE OF CONTACT, FLUSH
EYES WITH PLENTY OF WATER
FOR AT LEAST 15 MINUTES. CALL A PHYSICIAN. WASH SKIN WITH SOAP AND
WATER.

Flash Point Method:TOC
Flash Point:=-3.3C, 26.F
Lower Limits:2%
Upper Limits:12%
Extinguishing Media:CO2, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:TREAT AS SOLVENT FIRE.

Spill Release Procedures:PROVIDE ADEQUATE VENTILATION: TAKE PRECAUTIONS
AGAINST ALL SOURCES OF IGNITION.
SCOOP BULK OF MATERIAL INTO CONTAINER FOR DISPOSAL. CLEAN UP WITH RAGS
AND SOLVENT.

Handling and Storage Precautions:KEEP AWAY FROM HEAT, SPARKS, AND OPEN
FLAME. USE ONLY WITH ADEQUATE VENTILATION,.
AVOID PROLONGED OR REPEATED BREATHING OF VAPOR OR SPRAY MIST. AVOID
CONTACT WITH
SKIN AND EYES.

Ventilation:TO MAINTAIN TLV
Eye Protection:SAFETY GLASSES
Other Protective Equipment:ALL CHEMICALS SHOULD BE HANDLED SO AS TO
PREVENT EYE CONTACT AND EXCESSIVE OR REPEATED SKIN CONTACT.
APPROPRIATE EYE AND SKIN PROTECTION SHOULD BE EMPLOYED, INHALATION
OF DUSTS AND VAPORS.
Supplemental Safety and Health

Boiling Pt:=80.C, 176.F
Vapor Pres:71 MM HG AT 20 C
Vapor Density:2.5
Spec Gravity:0.89
Solubility in Water:INSOLUBLE
Appearance and Odor:TAN LIQUID, KETONE ODOR,
Percent Volatiles by Volume:60%

Stability Indicator/Materials to Avoid:YES
Hazardous Decomposition Products:CARBON COMBUSTION PRODUCTS, NITROGEN
COMPOUNDS
Conditions to Avoid Polymerization:WILL NOT OCCUR.

Waste Disposal Methods:INCINERATE OR ALLOW SOLVENT TO EVAPORATE AND
DISPOSE OF SOLIDS IN LANDFILL.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.